P0B50 BMW Fault Code
Check P0B50 OBD Fault Code ReasonThe Throttle Position sensor signals the Engine Control Module as to the current position of the engine throttle valve.
The current throttle valve opening is based on the driver's input from the gas pedal.
The ECM uses the information from this sensor to help calculate fuel delivery and spark timing.
P0B50 Code Symptoms :
If your P0B50 check engine light is illuminated, it's best to take it in for diagnostic testing, which can feel like a hassle. Because while the lights vary in appearance from vehicle to vehicle, all have the same basic meaning: There's a problem with the car's emissions system. The on-board diagnostics system P0B50 and engine control unit are in charge of monitoring a bunch of different , and if they get a reading that's a little out of whack, up pops the check engine light.
Diagnosis And Repairing P0B50
P0B50 OBD2 specifically refers to the camshaft (cam) timing. In this case, if the cam timing is over-retarded, the engine light will be illluminated and the code will be set.
How to fix P0B50 code ?
- Faulty Air Flow Meter
- 1Camshaft Position Sensor circuit poor electrical connection
- Faulty ignition coil (s)
- Oil Control Valve (OCV) circuit is open or shorted
Gear changes are accomplished by a command from the BMW TCM to energize the clutch actuator to release the clutch; after which various actuators inside the transmission disengage the current gear, and depending on current operating conditions, engage the next higher or lower gear ratio. All of this happens much faster than a human driver could change gears, and in most applications, gear changes are as smooth and seamless as on any fully automatic transmission.